Skunkx can be bought online. Furthermore, in the Netherlands we work with a close network of chiropodists and regularly participate in tradeshows and exhibitions.

Skunkx are currently available in 3 sizes: 36, 38, 40.5. 39, 42 44 are on the way.
Additional sizes will be available in the future.
Inside the shoe a thick layer of sheep wool is used, so that there is always a good fit with your feet.

The soft vibro massage stimulates your feet and legs. Massaging your feet for a couple of minutes and then turning off the message function will give you a pleasant tingling feeling, helping to rejuventate sore and weary legs. The massage function switches off automatically after 30 minutes of use to prevent overstimulation. Use the massage function for a maximum of 30 minutes per hour.

Switch to constant heat mode for extra warmth as explained in the manual, or simultanuously switch on the massaging function and the heating function for maximum blood flow stimulation in the feet and legs.

Skunkx heat up in 3-4 minutes up to approximately 39°C, no hotter. When using them for longer periods of time, people indicated that this is the ideal temperature for feet, without them getting too warm.

Yes, you can download the Skunkx brochure here...

You can download the Skunkx manual here ...

We recommend that you do not wear your Skunkx outside, especially not when it is raining.

  Rub the suede gently with a bath towel to restore some of its natural look. Remove dry stains and marks from suede by gently rubbing a pencil eraser on the affected area. For wet stains lay a papertowel on top of the stain to absorb most of the liquid. Do not apply any kind of stain remover or other products. Brush with a suede brush. Gently rub the surface of the shoe with a cloth, then allow it to air dry. Because Skunkx contain electronics, they should never be immersed in water, nor should you clean them with a large amount of water. If the soles are dirty, use a lightly dampened cloth. DO NOT scrub, rinse or wipe near the interface as this may damage the electronics, or worse, result in harm for the cleaner.  

When the battery low indicator starts flashing red it's time to charge your Skunkx. To do so, plug the charger into a wall socket and connect the charger to both shoes. When the charger light turns green your Skunkx are fully charged and ready for use. If you are charging Skunkx for the first time, it may take longer to charge.

Skunkx are operated by two buttons, one to turn the heater on and off and the other to turn the massage on and off. A simple light indicator tells you whether Skunkx are on or off or need to be recharged.

Skunkx are available in three versions, fully black, sand and brown.